Question:
Is it possible to use beam elements for convection or radiation?Applies to:
- nTop 3.9.3
- Thermal Analysis
Knowledge Base
- Knowledge Base
- How to import and use superelements
- Why is the deformation scale not working?
- How to apply prescribed displacement
- How to use point mass
- How to run homogenization
- How can I set up a simulation?
- How to run a static analysis
- How to run a thermal analysis using a thermal bonded contact
- How to run a thermal analysis
- How to run a nonlinear thermal analysis
- How to run a transient thermal analysis
- How to run a buckling analysis
- How to use Boundary Conditions
- How to use simulation results to create a Point Map or Field
- How to create a Simulation Model for a simple shell lattice
- How to select boundaries of an FE Mesh - FE Boundary by Flood Fill
- How to select boundaries using Boundary by Body
- How to use a CAD Face in a boundary condition
- How to create CFD Boundaries
- How to create a material
- How to create a Simulation Model
- How to determine the heat flow on a specific part of your model
- How to determine a Nastran classification for an nTop block
- Methods for connecting multiple FE meshes in an Simulation model
- How are the loads distributed for bearing force?
- How to create a simulation model with multiple materials
- How to apply torsional load
- How do I use temperature units?
- Can I run a fatigue or nonlinear static analysis?
- How to create an FE Mesh for a complex shell lattice
- Can I perform convection and radiation analysis on beam elements?
- How to shell a lattice to get a shell mesh and connect it to a solid mesh
- What are the options for simulating lattices?
- Can I run an analysis with a force of 0?
- Can I apply a centrifugal force to my part?
- Can I export the material from the Homogenize Unit Cell?
- How to display and view imported CFD data
- No mesh entities were found in FE Boundary
- NAFEMS Benchmark Tests for nTop FEA Solver
- How do I use the Mirror FE Mesh block?
- I ran a simulation but my results don't show up as expected
- How to use reaction forces in a secondary analysis
- How to find the maximum and minimum stress values
- Why do some Boundary Conditions use an FE Region instead of an FE Boundary?
- Are there default environmental properties present when running a simulation?
- A node is tied twice in two different Tie Constraint connections
- Analysis is expecting a non-singular matrix
- The simulation results window isn't appearing
- How to analyze a pipe for internal pressure
- Can I edit the coordinates of an Orthotropic material?
- Number of degrees of freedom in LHS and RHS aren't equal
- How to use Ramps to create varying fields for FEA Materials and Boundary Conditions
- What are Interpolation options for creating a Field from a Point Map
- How to extract the scalar field from a vector field
- Failed to apply periodic boundary conditions. Please check the Design volume
- Why is there no result in the defined frequency range for a Modal Analysis?
- How to export reaction forces
Access and Installation
What's New?
Can I perform convection and radiation analysis on beam elements?
How to create an FE Mesh for a complex shell lattice
Previous
How to shell a lattice to get a shell mesh and connect it to a solid mesh
Next
⌘I
Assistant
Responses are generated using AI and may contain mistakes.